After running a command which may change the state of the current repository, the current Magit buffer and the corresponding status buffer are refreshed. The status buffer can be automatically refreshed whenever a buffer is saved to a file inside the respective repository by adding a hook, like so:
(with-eval-after-load 'magit-mode (add-hook 'after-save-hook 'magit-after-save-refresh-status t))
Automatically refreshing Magit buffers ensures that the displayed information is up-to-date most of the time but can lead to a noticeable delay in big repositories. Other Magit buffers are not refreshed to keep the delay to a minimum and also because doing so can sometimes be undesirable.
Buffers can also be refreshed explicitly, which is useful in buffers that weren’t current during the last refresh and after changes were made to the repository outside of Magit.
magit-refresh) ¶This command refreshes the current buffer if its major mode derives
from magit-mode as well as the corresponding status buffer.
If the option magit-revert-buffers calls for it, then it also
reverts all unmodified buffers that visit files being tracked in the
current repository.
magit-refresh-all) ¶This command refreshes all Magit buffers belonging to the current repository and also reverts all unmodified buffers that visit files being tracked in the current repository.
The file-visiting buffers are always reverted, even if
magit-revert-buffers is nil.
This hook is run in each Magit buffer that was refreshed during the current refresh - normally the current buffer and the status buffer.
When this option is non-nil, then the status buffer is automatically refreshed after running git for side-effects, in addition to the current Magit buffer, which is always refreshed automatically.
Only set this to nil after exhausting all other options to improve performance.
This function is intended to be added to after-save-hook. After
doing that the corresponding status buffer is refreshed whenever a
buffer is saved to a file inside a repository.
Note that refreshing a Magit buffer is done by re-creating its contents from scratch, which can be slow in large repositories. If you are not satisfied with Magit’s performance, then you should obviously not add this function to that hook.